Doorgaan naar hoofdcontent

Containers for Reigerkuitenvet...


I generally distribute Reigerkuitenvet as ‘half dome’ pucks in plastic ziplock baggies. For on-stream use I use small craft-shop screw-lid containers. However either way is less than ideal for actual use - I wanted something that gives instant access to a puck on the water without having to fumble with a baggie, to break off a piece to treat a leader, or to take the whole puck out of a container. Something that, after opening, gives full access to the puck so that I can hold the opened container and draw my leader straight through the line dressing. So I came up with the following design, easily turned on the lathe, from whatever wood, preferably nicely figured wood, you have lying around - as long as it will yield at least a 45 mm diameter spindle.


Reacties

Een reactie posten

Populaire posts van deze blog

Update hollowing jig

 Some time ago I showed my hollowing jig for (female) bamboo ferrules. That version consisted of a small slab of wood with a groove, the depth of which defines the resultant wall thickness, and a spokeshave to remove material from the inside of a strip, down to the desired wall thickness. While functional, that small jig wasn't completely satisfactory, for a number of reasons. In addition, the (unmodified) spokeshaves were less than totally satisfactory, as they kept digging into the surface of the jig when reaching the final wall thickness. So I updated my hollowing jig, making it from a large, heavy slab of well seasoned European oak (from a 50 year old discarded table, sawn to length and planed to thickness (using a large workshop jointer and a lunchbox thickness planer). I made a number of grooves with a plunge router, of different depth (wall thickness) - on one side for general hollowing (wall thicknesses roughly between 2 and 3 mm), and for female ferrule hollowing on the ot...
Een reactie posten
Meer lezen

Waara V-block

I usually check my strips for dimension (both correspondence to the design thickness from the taper plan and consistency flat to flat) by carefully taking measurements with a digital caliper. I know that this is less than accurate, since the apex, which is always one of the reference ‘sides’, is very easily crushed, resulting in an undersize reading (the actual crushing of the apex itself is not so much a problem). There are better, more accurate ways, to measure dimensions of a (equilateral) triangular strip. The most common approach among bamboo rod makers is to use a so-called Waara v-block, named for the rod maker (and machinist and inventor) who popularised it and manufactured them for sale. The principle behind it is that you put a strip in a 60 degree v-groove in a block that has a cutout for a pair of calipers, supporting the apex side of the strip with the groove, rather than by its apex alone, and measuring the thickness of the strip-plus-block. If you know what the net thick...
Een reactie posten
Meer lezen

New 4-string binder

Some time ago, a fellow rod builder asked whether I could make him a 4-string binder like the one I currently use, and take with me to meets and demos. I said, sure, why not, so I started assembling and making parts, considering what upgrades I could incorporate – better motor mount, better balanced drive wheels, larger foot plate, smaller thread spools with no protruding wing nuts, thread tensioners that attach to the binder wheels in a less jury-rigged manner, and thread guides made from steel rod rather than sections of cheap fiberglass coarse fishing rods. Oh, and real flanges with grub screws to fix the rear upper drive wheel and the front binder wheel to the main axle, rather than epoxying them in place… So I set about doing all that, and am now nearing completion, only waiting for a new sewing machine motor and drive belt, and a set of sewing machine thread tensioners, to be delivered before I can finalize the build. Here are some intermediate build pics. Drive wheels provisiona...
Een reactie posten
Meer lezen